How to set LED screen parameters?
Author:Zhang Haifeng Time:2021-06-07 10:13 Browse(836)
The specific steps of LED screen parameter setting are as follows: 1
The specific steps of LED screen parameter setting are as follows: 11、 The first step is to download the compressed package of the software on the Internet, extract it to the current folder, and then click the extracted file, as shown in the figure below.2、 Next, click OK on the software, and then click next, as shown in the figure below.3、 Step 3: next, click Install, and then click finish after installation, as shown in the figure below.4、 Step 4: on the computer desktop, open the installed software, and then click Set, and then click set screen parameters, as shown in the figure below.5、 Next, enter the password of the software (password 168). After entering, click the screen parameter installation address, and then enter the IP address of the screen, as shown in the figure below.6、 The sixth step, next in the screen control width, and other information, and then you need to set according to the real screen, and then after setting, click save, as shown in the figure below.. You can see the unit board. Do you remember what control card you used? I know the model of the control card. Everything's fine.