How does sharp connect his lcd-40v3a to a satellite receiver?
Author:Yang Wen Time:2021-09-09 13:32 Browse(502)
How to use satellite TV receiver: step one
How to use satellite TV receiver: step one. When using a digital satellite TV receiver, we must first determine the type of receiving satellite, and then we can find the parameters of the receiving satellite. This is what we usually call the process of satellite searching, and it is also the most important step for a digital satellite TV receiver to be able to broadcast high-quality TV... How to use digital satellite TV receiver: Step 2.. After determining the satellite, the receiver, antenna (Pan) and TV should be connected. At this point, if you know the three angles (polarization angle, elevation angle and azimuth angle) of the satellite to watch, the installation process is simple. Adjust the three angles of the antenna, and then input parameters on the receiver to wait for the channel to appear. Of course, in many cases, I don't know about the three corners, so the installation is relatively slow. At this time, the first thing to do is to connect the equipment and turn on the TV and receiver. Input the parameters of any TV station on the satellite to be watched in the receiver, save them, and then tune them to the station where the parameters are input. At this time, the information displayed on the remote control of the receiver can be seen on the TV at the same time. At the bottom is the constant strength indication, and the signal strength is about 70 / 100( 7) signal quality is zero. At this time, it is necessary to carefully rotate the antenna up and down, left and right, and the angle of the high frequency head, and observe the TV while rotating. When the image is displayed, it means to find the satellite, and then make subtle adjustments to make the image clearer. The guiding quality is more than 40 / 100.. If the satellite receiver has HDMI interface, connect the receiver and TV with HDMI cable, and set the signal source of TV as HDMI;. If there is no HDMI interface, use yellow, red and white AV video cables to connect the receiver and TV, and set the TV signal source to AV video mode..

How does sharp connect his lcd-40v3a to a satellite receiver?

Related topics