Production operation and maintenance cycle of high pressure defoamer
Author:Cui zaishan Time:2021-06-11 13:35 Browse(75)
Production operation and maintenance cycle of high pressure defoamer, touch screen and OLED Forum
How important is safety in production! Today, the production operation and maintenance cycle of a full-automatic high-pressure defoamer:% ^ + G (E4, n| 8 J# t) h4 J9 N    B - A. y '{automatic high-pressure defoamer is usually used to eliminate the bubbles in the process of polarizer lamination and mobile phone screen lamination.

Production operation and maintenance cycle of high pressure defoamer

it is widely used in the mobile phone repair profession and can improve the defoaming quality.
in order to adhere to the high performance of automatic high-pressure defoamer.
excellent operation condition, The usual protection and maintenance is indispensable.
so how to maintain the automatic high-pressure defoamer?" V7 c! c$ c/ _( [ 1 I1. Admit whether the set values (SV value and PV value) of the temperature regulator of the high-pressure deaerator are accurate. If the PV value is set disorderly.
even if the equipment is in normal condition, there will be high temperature and high pressure. Please set according to the operation manual.
if the equipment is in normal condition, there will be high temperature and high pressure7 S.
b8 u    G1 a)F4 E2 N3 u, R2 ~)} - D2. For the electrical components of the high-pressure defoamer, we should clean them according to the manual to see if the screws of each part are tight enough. For the pneumatic components, we should often check whether each part is in doubt, and we should check the sealing condition of each interface punctually during the inspection of the seals.
for the high-pressure defoamer, we should clean the electrical components according to the manual- [.
C! Q+ R, R( w, q, B! J* a# E7 c% k6 Y9 g0 ^8 b- N0 ?3. After using the high-pressure defoamer for half a year, it is necessary to check whether the door mat is damaged? If there is an injury, air will leak from the door when pressurized,The sound of air leakage can be heard, so please replace it.
will the set value be the same as the operation manual? If the setting value is high, the temperature will rise unsteadily, so please set it as the value recorded in the operation manual.
+ H-O.
F% ` 5 R5 n, u7 Z, w! S (C% X. Z $o (K4. After 12 months of use, it is necessary to admit whether the drive belt used for the ventilator is cracked.
if the drive belt is cracked.
even if the motor is working, the ventilator will not rotate.
therefore, please replace the new drive belt.
also confirm whether the pressure gauge shows 0mpa when there is no pressure? If the fluctuation is high.
it is impossible to accurately indicate the pressure in the cylinder# T2 E' M. f6 l2 q0 R.
|2 g / M $^ 5 C / J 1J no matter when we are in accordance with the manufacturer's requirements to guide the production parameters and maintenance!: N: X5 F& H( G) Q    D4 f$ |% e7 u. O( y2 C; V) A.
.
.
.
.
.
Related topics