Solution to the problem of edge yellowing of products formed by laser cutting small pieces
Author:Wang Anqi Time:2021-06-08 11:21 Browse(342)
K4274
Sensor process: after laser cutting, the edge of the product turns yellow. At present, clean the edge of the product with a dust-free cloth dipped with an appropriate amount of alcohol, because there will be residual alcohol stains after wiping the edge of the product (the purity of alcohol is 99.97%), that is, clean the surface of the product after cleaning the edge, which is a waste of manpower and material resources.. 1. What material? ' Y1 Z) ?6 |% B1 Z" @2. What kind of technology? Half cut, full cut? & x" q* M7 c  Z& N: S% z3. Domestic laser cutting machine or imported laser cutting machine? How much power?' d4 o" B: Y' C. B; ["Z5 K9 Z / D / T this laser cutting yellowing is very normal, because the laser is thermal cutting. But if the parameters and power are adjusted properly, the effect will be better. First answer the above three questions.. Otherwise, it's not clear what the reason is.. If the power is too high, there will be a small amount of smoke in laser cutting single sensor. On the premise that the power can be cut off, if the power is reduced and the speed is fast, the effect of a ventilation is not ideal. It depends on the structure of the cutting. It just depends. The frequency and power parameters should be adjusted.

Solution to the problem of edge yellowing of products formed by laser cutting small pieces

Related topics